Bluesolar PWM charge controller with USB output and LCD screen
Victron Energy has launched a new series of solar charge controllers with an LCD screen and 2 USB outputs. The models for 12 and 24 V battery voltage have automatic voltage detection and range from 5A to 30A. The 48V models have a charge current of 10, 20 or 30A.
Liquid crystal display
For status monitoring and set-up
Load output
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage. Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
